3d printed intake for Motobecane AV10 engines. Made by the pros at Doppler to give optimal intake flow.
19mm ID and 25mm OD on the intake itself.
Rubber couple will accept spigot mount Dellorto PHBG carburetors.
CAUTION: the material used is sensitive to clamping, it is imperative not to exceed the clamping torque (4 Nm), and not to forget to use the washers provided. In the case of incomplete sealing, give preference to the use of the joint leg, rather than excessive clamping of the screws which would cause the sole to deform.